How do I program my Shaw Direct remote to my TV?

How do I program my Shaw Direct remote to my TV?

How to program your IR/RF 600 remote to your satellite receiver

  1. Press and hold “ENTER” and “MUTE” until the mode buttons flash in rotation.
  2. Enter the remote code: Receiver Codes. 000. 001. 002. 003. 004. 005. 006. 007.
  3. Press “ENTER”. The mode buttons should flash twice.
  4. Press “Guide” to confirm the code was successful.

How do I pair my Shaw remote?

Press and hold the SHAW button and wait for the remote light to change from red to green. Then type in the three-digit code on the TV screen. Press OK to complete the pairing. Once your remote is paired, follow the TV on-screen instructions to set up control for your TV and audio device.

How do I reset my Shaw remote control?

Performing a factory reset

  1. Activate the programming mode on your remote.
  2. Press 9 – 8 – 1.
  3. The LED will blink green twice to indicate that the remote was reset.
  4. After the factory reset is complete, you’ll need to re-pair your remote with a TV box.

What is the code to a universal remote?

4 digit codes for GE Universal remote controls (DVD Players)

Brand 4 Digit Code
PHILIPS 0398 0408 0423 0755 0979 0981 0980 0456 0458 0969
PHILIPS-MAGNAVOX 0398 0408 0423 0979 0980
PIONEER 0403 0404 0976 0977 0968 0909 1084

How do you code search One For All remote?

Searching for Codes One-For-All URC10820 Universal Remote

  1. Turn on your TV and on the remote control, press TV once.
  2. Press and hold SET until the LED (red light) blinks twice, then release SET.
  3. Enter 9 9 1.
  4. Select a test function from the list below or use the default test function (POWER) and skip step 4.

How do I fix my Shaw Direct remote?

My receiver is not responding to my remote control

  1. Press SAT button on your remote.
  2. Press any buttons and check if SAT button lights up. If the SAT button lit up, your remote is working fine. If the AUX or TV buttons lit up, press the SAT button again. If no buttons lit up, replace your remote’s batteries.

Why won’t my remote work with my cable box?

Troubleshooting Steps Replace your batteries. Make sure your Spectrum Receiver (cable box) is turned on. Change channels by pressing the buttons on your receiver (if available). Remove any objects (e.g. furniture) around your receiver.

What is enter code?

Enter Code is a feature that is available for a limited number of users. It is currently not possible for anyone to generate a code to use at this time. The app will not follow a generic URL or just any QR code found on the street. If it isn’t a Ride with GPS app code then you will get the error “Invalid Code”.