How do I save settings on HP ProCurve?

There are three ways to save a new configuration:

1. In the CLI: Use the write memory command. This overwrites the current startup-config file with the contents of the current running-config file.
2. In the menu interface: Use the Save command.
3. In the WebAgent: Click Save.

How do I reset my HP ProCurve 2824 to factory settings?

To execute the factory default reset on the switch, perform these steps:

1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
2. Continue to press the Clear button while releasing the Reset button.
3. When the Self Test LED begins to blink, release the Clear button.

How do I show running config on HP switch?

To display the running configuration using the WebAgent:

1. In the navigation pane, click Troubleshooting.
2. Click Configuration Report.
3. Use the right-side scroll bar to scroll through the configuration listing.

How do I upload config files to HP switch?

To copy a configuration file from a USB device to the switch:

1. Insert a USB device into the switch’s USB port.
2. Execute the following command: HP Switch# copy usb startup-config HP Switch-config.
3. At the prompt, press [Enter] to reboot the switch and implement the newly downloaded software.

How do I backup my HP switch using putty?

2 Replies

1. If you use putty run the “sh run” command, this gives you the complete configuration of the switch.
2. Starting at the bottom, select the most right pixel, drag you mouse to the left, and than up, until you see your “sh run” command.
3. Hit enter (it is now copied to your clipboard)

How do I reset my HP ProCurve 2510 24?

How to reset a ProCurve 2510-24g to default settings

1. Press in both the Clear and Reset buttons (tiny buttons on the left edge)
2. Release the Reset button after the port lights come on (~2 seconds)
3. When the Self-Test LED starts flashing (to the left of the Clear and Reset buttons), release the Clear button.

How do I factory reset my HP ProCurve 2626?

Factory Reset When enabled, the switch can be reset to factory defaults by depressing the “Clear” and “Reset” buttons together, releasing the “Reset” button while holding the “Clear” button down, and releasing the “Clear” button as soon as the “Test” light begins to flash rapidly.

What is show running config command?

The show running-config command shows the router, switch, or firewall’s current configuration. The running-configuration is the config that is in the router’s memory. You change this config when you make changes to the router.

How do I download config files from HP switch?

How do I copy a configuration file from HP switch?

To copy the startup configuration file to a USB flash drive:

1. Insert a USB device into the switch’s USB port.
2. Execute the following command: HP Switch# copy startup-config usb HP Switch-config. where HP Switch-config is the name given to the configuration file that is copied from the switch to the USB device.

How do I copy a switch to a config?

Telnet the first switch, copy the configuration on a simple text file using the show run command and paste it in the text file. Then connect to the new switch using a serial connection, go to the global configuration mode and paste the configuration to it. Alternatively you can use a TFTP server.