Is the common wire hot in a 3-way switch?

Black wire: This is a hot wire that carries electricity from the power source to the first switch in a typical 3-way setup. It’s also called the “common wire” or the “line wire.” Unless the breaker is off, this black wire is always hot.

Does it matter what wire goes where on a light switch?

It doesn’t matter as long as you do it the same on both switches. So, if you connect it to the upper right terminal on one switch, connect it to the upper right terminal on the other switch. Connect the second traveler wire to the terminal opposite the red wire terminal.

What are the different parts of a 3 way light switch?

There are three screw terminals on the body of the switch, in addition to the green grounding screw. One screw, known as the common, is a darker color than the others. The other two screws, usually a lighter brass color, are known as the traveler terminals.

What happens if you wire 3-way switch wrong?

If you don’t correctly connect this wire, then your lights won’t work from more than one switch. Grounding the switch: You’ll also need to locate the ground wire and connect it to the switch too.

What color wire goes to the black screw on a 3-way switch?

Tighten the terminal screws. Connect the ground wire to the green screw, then connect the wire marked common to the black or dark colored screw. Connect the two remaining traveler wires to the two brass or light colored screws.

Where does the black wire go on a three-way switch?

The black hot wire connects to the far right switch’s common terminal. Red and blue wires link traveler terminals of both switches. The red wire, which is connected to the first switch’s common terminal, leads back to the fixture.

Is the black screw on a 3 way switch the common?

When disconnecting the wires, mark the wire on the black or dark colored screw as common. Mark the wires on the brass or light colored screws as travelers. Make notes or take a picture to verify connections before removing the old switch. Mark the wires on the brass or light colored screws as travelers.

Does it matter where black and white wire goes on light switch?

A standard single pole light switch will simply require you to attach the black (load) wire into it, and then the black wire leaving the switch and to your lights. The switch serves to cut the power from reaching the light switch. The white or neutral wire bypasses the switch and goes straight to your lights.

Does the black wire go to L1 or L2?

The incoming circuit wires that provide the power are referred to as the line wires. L1 (line 1) is a red wire and L2 (line 2) is a black wire.