What axles are in a 1989 F250?

Making Sure That Your Truck Has A Ford Sterling 10.25 Axle If you have a 1986-1997 Ford F250 or F350, it should have a Sterling 10.25 axle.

What axle is in a Ford F250?

For the 2017-2019 F-250, the front axles are still a 35 spline Dana 60 axle. In the back, the 10.5” is still standard but trucks fitted with the Heavy Duty Towing Package are set up with a Dana M275 axle.

What years did Ford use Dana 50?

The solid axle Dana 50 was used in the Ford F-250 and the F-350 from 1999 to 2003. This axle was also the only OEM axle used in Four-wheel drive Ford Excursions. The GAWR of a solid axle Dana 50 is 5000 lbs.

What years did Ford have solid front axle?

According to ALLDATA, four-wheel-drive Ford half-tons used the TTB setup with coil springs and radius arms from 1980 to 1987. The 1/4- and 1-ton trucks used the TTB with leaf springs from 1980 to 1987 — with the exception of the 1986-1987 F-350 with the Dana 60 (monobeam) solid front axle.

What years did Ford use Dana 60 front axle?

Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks.

What trucks have Dana 60 axles?

The Dana 60, a heavier-duty axle than the Dana 44, was first used in the 1950s. It was the axle of choice under countless Dodge, Ford, GM, Studebaker, IH and Jeep 3/4-ton and 1-ton fullsize trucks, as well as Ramchargers and Trail Dusters with the 440ci V-8, and some heavy-duty 1/2-ton Ford and IH trucks.

When did Ford stop using the Dana 50?

2003
Bolted under the front of the Super Duty well into the middle of 2002, and equipped on most 4×4 Ford Excursions, the Dana 50 front axle was a carry-over axle that Ford finally phased out officially by the end of 2003.

What trucks have Dana 60 front axles?

What year did Ford stop using straight axles?

Solid front axles, non drive wheels was 1964 the last year. Then in 1988 the Ford F-Super Duty (F450) came out with a solid front axle with 10 lugs per wheel, Dana 80 rear axle with disk brakes.

Which trucks have solid front axles?

Even though we are now down to just three new vehicle models available with a solid front axle in the U.S.—Jeep Wrangler, Ford Super Duty, and Ram heavy-duty trucks (four if you count the über-expensive Mercedes G-class)—we’re still huge proponents of the driven beam axle construction for off-road use.

What trucks have Dana Super 60?

Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks. Each axle is built with a Bill of Material (BOM) Tag affixed to the differential cover by two cover bolts.

How do you tell if I have a Dana 44 or 60?

Many Dana axles have the model ID cast into the fins or centersection. Look for a “44” or “60” cast into the reinforcement ribs. The number can usually be found on the lower right side rib below the differential cover, but it may also be found on other ribs or on top of the main cast structure.