When I turn the key on my riding mower nothing happens?

Check/clean/tighten all connections on battery/solenoid/starter/Ignition switch and neg(-) cable to frame or motor. Check to ensure all safety features are working properly and not engaged. Check for an inline fuse, bypass solenoid to see if engine cranks if it does replace solenoid, if no crank replace starter.

Why can’t I get my riding mower to start?

Your Mower Won’t Start: Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.

How do I know if my lawn tractor solenoid is bad?

A riding lawn mower solenoid may be bad when you hear a click or hum when you turn the ignition key and your mower doesn’t start. Another indication your solenoid may be bad is when a wire gets hot and begins to smoke or melt.

How do I know if my riding mower starter is bad?

A riding lawn mower that has a bad starter can be difficult to diagnose. A bad starter can manifest itself in a cranking noise without engine turnover, a clicking when the ignition button is pressed, or a mower that simply does not respond to attempts to start.

How do I know if my riding lawn mower solenoid is bad?

Look for the large terminal posts on the solenoid where the thick red wires connect to the solenoid. Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced.

How do you check ignition key?

Put the ignition key into the ignition switch and crank the engine. If the engine cranks, then your ignition switch is obviously working fine. If the engine does not crank, and you hear a “click” when you first turn the key to the “III” position, then your ignition switch is not the problem.

How do you start a lawn mower with a screwdriver?

How to Start a Riding Lawnmower with a Screwdriver, try these two methods

1. Step 1: Engage the mower’s brakes.
2. Step 2: Disengage the blades.
3. Step 3: Locate the battery and ignition coil.
4. Step 4: Use a screwdriver to bridge the mechanism.
5. Step 1: Engage the brakes and disengage the blades.

Will mower start with bad solenoid?

Symptoms of a Bad Solenoid on a Riding Lawn Mower A riding lawn mower solenoid may be bad when you hear a click or hum when you turn the ignition key and your mower doesn’t start.