Why does my creepy crawly stay in one spot?

If your Kreepy Krauly is often stuck at one side of your pool there are two potential fixes. If the hose is too short then buy another line and have it extended out enough to cover the pool. On the other hand, if it is constantly being coiled then relaxing it or changing how you keep it stored will fix that problem.

How do you adjust a Kreepy Krauly?

If Kreepy Krauly is moving too fast. If that doesn’t slow down the Kreepy cleaner enough, you can adjust the regulator valve. To decrease the speed of Kreepy Krauly, open up the manual bypass fully, on the bottom of the regulator valve. The regulator valve fits in between the skimmer and the Kreepy hose.

Why is my Kreepy Krauly not moving?

The most common cause for a Kreepy to stop working is clogged filter sand. This is easy to diagnose because whenever you backwash the pool filter, you’ll find that the Kreepy works like a bomb for 10 minutes. Then it gets sluggish and slows down or stops again.

Where do you put the weights on a creepy crawly?

For pools 4′ deep or less, use 1 hose weight 4″ to 12″ from the cleaner. For pools of 4-7′ deep, use 2 weights, one 4″ to 12″ from the cleaner and one 6′ from the cleaner. For pools from 8′ to 12′ deep, use a third weight, placed 10 ft. from the swivel end of the cleaner.

Why does my Kreepy Krauly stay in the deep end?

Usually if the Kreepy Krauly is staying in one end of the pool the problem is 1 of 3 things. The flow of water from the return is keeping the KK in one area, or the hose may not be the correct length, or the hose may not have the correct balance.

Why does pool cleaner get stuck in corner?

Flow Adjustment The stronger the water flow, the more likely it is to get stuck in one place. You need some suction though or the pool won’t get cleaned properly. The easiest solution is a flow keeper valve. A flowkeeper valve is a valve that regulates the flow of water through the hose going to the cleaner.

Why does my pool cleaner go in circles?

Your first issue is to resolve the problem of the cleaner getting stuck or going in circles. This is most likely caused when pool cleaners are left in the pool 24/7. When the water is cold or cools off from a warm day, the plastic in the hose gets a memory and curls slightly.

Why is my pool vacuum not moving?

When a suction cleaner is sluggish or slow, it’s usually a clogged pump basket or dirty filter that is to blame. Other problems include holes in the cleaner hose, sucking air into the hose, or the filter pump could be drawing in air, reducing water-flow volume.

Why does my pool pump not have suction?

It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.

What do pool hose weights do?

Hose weights help to keep the head of the cleaner flush with the floor of your swimming pool and able to suck up all the dirt that makes its way there.

Why is my pool cleaner not moving?

Most likely, the key reason is a congested pool filter or skimmer basket, or a clog at the mouth of your pool cleaner. If you own a particularly powerful pool pump or your water-flow is really strong, your cleaner will probably move faster than normal.