Do new Fender guitars need a setup?
Make sure you’re getting the best out of your guitars. Although it would be great if all guitars sounded perfect and played like a dream straight from the factory floor, most guitars will require a “setup” before achieving their full potential.
How high should Telecaster strings be?
A good place to start for the action on a Tele is 4/64″ on all the strings. Depending on the guitar and playing style, the action can be adjusted slightly lower or higher from this starting point. To measure the height of the strings at the nut, measure from the top of the first fret to the bottom of the string.
How do you set the intonation on a Fender Telecaster?
Setting Intonation on a Tele
- Pick the open string and verify it’s in tune.
- Fret at the 12th fret and pick this note.
- If the 12th fret note is flat, move the saddle forward a little by turning the adjustment screw at the back of the bridge (counter-clockwise) using a flat or philips screwdriver (whatever is appropriate).
How high should the nut be on a Telecaster?
The top of the nut is shaped to follow the radius of the fretboard, and the string slots also follow this curve. To allow the strings to clear the top of the first fret, the bottoms of the slots should be . 030″ higher than the fret height.
How do I set up my Telecaster guitar properly?
011″ (0.3 mm) from the first saddle. Move the third saddle back from the second saddle using the gauge of the third string as a measurement. The fourth-string saddle should be set parallel with the second-string saddle. Proceed with the fifth and sixth saddles with the same method used for strings two and three.
How much does a guitar setup cost?
Generally speaking, a professional setup costs around $50, but it could be upwards of $100 if there’s a lot of work to be done. New strings are usually part of the setup process, since the gauges of the strings affect intonation.
What gauge strings come on a Telecaster?
Answer: Out of the box, most of the Telecaster guitars come equipped with 9-42 strings.
How high should strings be off first fret?
String Height at the 1st Fret
|Low Action||“Normal” Action|
|Low E: 0.51mm (0.020”) High E: 0.30mm (0.012”)||Low E: 0.76mm (0.030”) High E: 0.41mm (0.016”)|
What happens if you loosen truss rod too much?
If your truss rod is too loose, it will result in a concave neck bow, (action too high) and a truss rod that is too tight will result in a convex neck hump (action too low and causing fret buzz). The truth is that the truss rod is a simple device that has one purpose: to counter the pull of the strings. That’s it.
Does tightening truss rod lower action?
A truss rod is not for adjusting action. A truss rod is NOT for adjusting action. Despite the fact there is information around the web telling readers to adjust their truss rod to raise or lower action, a truss rod is not for adjusting action.