How do I turn off auto MDIX?

To disable Auto MDIX on a port, use the no mdix auto command under the interface configuration mode. To put it back to default, use the mdix auto command in the interface configuration mode.

How do I connect two Cisco 2950 switches?

Plug one end of the cable into one port. Then, plug the other cable end into the other: if you immediately get a link LED on both ports, disconnect the cross-over cable; if no LEDs, you’ve probably got yourself a straight-through.

What is no MDIX auto?

Auto-MDIX on an Interface When connecting switches without the auto-MDIX feature, you must use straight-through cables to connect to devices such as servers, workstations, or routers and crossover cables to connect to other switches or repeaters.

How do I reset my Cisco 2950 to factory settings?

If indeed the switch has a MODE button on the front panel, Step 1: turn off/on the switch while holding the button down for roughly 15 seconds. Step 2: You will be able to view the led lights blink, and now the switch should have reset to default on system restart once you release the mode button.

What is Cisco MDIX?

Automatic medium-dependent interface crossover (Auto-MDIX) is a feature that allows the switch interface to detect the required cable connection type (straight-through or crossover) and automatically configure the connection appropriately.

What is write erase command?

Enter write erase, which erases the NVRAM. file system and removes all files. At the. prompt, confirm that you want to erase all files.

How do I reset my cisco 2950 password?

Step-by-Step Procedure

1. Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.
2. Unplug the power cable.
3. Power the switch and bring it to the switch: prompt:
4. Issue the flash_init command.
5. Issue the load_helper command.
6. Issue the dir flash: command.

What is the auto-MDIX feature on a switch?

Explanation: The auto-MDIX enables a switch to use a crossover or a straight-through Ethernet cable to connect to a device regardless of the device on the other end of the connection.

How do I wipe out my Cisco router?

Follow these steps:

1. Log on. to your switch, and enter the privileged EXEC mode by entering enable and then entering the enable password command.
2. Enter clear config all to reset the. entire system. You don’t need to reload the switch because processing the. command wipes the switch.